CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
2) Tighten the filter by turning it clockwise seven numbers from the makes point. For example, if a mark is made under the number 2 when the
rubber seal is seated, the filter should be tightened until the number 1 comes up to the marked point.
5. After installation, fill the engine with oil up to the specified level, run the engine for more than three minutes, then check for oil leakage and oil
level.
CAUTION: Installation using other than the above procedure could result in serious engine damage due to oil leakage.
