CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
Auxiliary Power Outlet: Service and Repair
Accessory Socket Test/Replacement
Front Accessory Socket:
1. Remove the center dashboard lower cover.
2. Disconnect the 2P connector from the front accessory socket.
3. Inspect the connector terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK, go to step 4.
4. Turn the ignition switch to ACC (I), and check for voltage between the No.1 and No.2 terminals.
-
There should be battery voltage.
-
If there is no battery voltage, check for:
-
blown No.27 (10 A) fuse in the under-dash fuse/relay box.
-
poor ground (G401, G402).
-
an open in the wire.
5. If all the tests prove OK, replace the front accessory socket.
Rear Accessory Socket:
1. Remove the left rear side trim panel.
2. Disconnect the connectors.