CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
8. Set the control shaft to [N] position, then install the A/T gear position switch on it.
9. Install the A/T gear position switch cover and harness clamp on the right side cover.
10. Connect the A/T gear position switch connector, then install it on the connector bracket.
11. Turn the ignition switch ON. Move the shift lever through all gears and check the A/T gear position switch synchronization with the A/T gear
position indicator.
12. Start the engine. Move the shift lever through all gears and verify the following:
-
The shift lever cannot be moved to [R] position from [N] position without the shift lever pulled.
-
The engine will not start in any position other than [N] or [P].
-
The back-up lights come on when the shift lever is in [R] position.
