CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
Seat Belt: Service and Repair
Front
Front Seat Belt
SRS components are located in this area. Review the SRS component locations, precautions, and procedures before performing repairs or service.
CAUTION: Check the front Beat belts for damage, and replace them if necessary. Be careful not to damage them during removal and installation.
Front seat belt:
1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the preset buttons.
2. Disconnect the negative battery cable, and wait at least 3 minutes before beginning work.
3. Slide the front seat forward fully.
4. Remove:
-
Center pillar lower trim panel
-
Kick panel
-
Front side trim
5. Remove the upper anchor cover and pull the lower anchor cover back.
6. Disconnect the seat belt tensioner connector.
WARNING: To avoid accidental deployment and possible injury, always disconnect the seat belt tensioner connector before removing
the retractor.
7. Remove the upper and lower anchor bolts, the retractor bolt, the retractor mounting bolt, and remove the front seat belt and retractor.
8. Remove the center pillar upper trim.
