CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
Cruise Control Switch: Service and Repair
Set/Resume/Cancel Switch
Set/Resume Switch Test/Replacement
1. Disconnect the battery negative cable, then disconnect the positive cable, and wait at least three minutes.
2. Disconnect the driver's airbag and front passenger's airbag connectors.
3. Remove the dashboard lower cover and knee bolster.
4. Disconnect the 6P connector between the cable reel sub harness and the main wire harness.
5. Check for continuity between the terminals of the 6P connector in each switch position according to the table.
-
If there is continuity, and it matches the table, the switch is OK.
-
If there is no continuity in one or both positions, go to step 6.
