CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
3. Inspect the connector terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK, go to step 4.
4. Turn the ignition switch to ACC (I), and check for voltage between the A and B terminals.
-
There should be battery voltage.
-
If there is no battery voltage, check for:
-
blown No.6 (10 A) and No.27 (10 A) fuses in the under-dash fuse/relay box.
-
faulty rear accessory socket relay.
-
poor ground (G401, G402, G553).
-
an open in the wire.
5. Remove the thermofuse housing and thermal protector, then remove the socket and cover.
