CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
21. Place a jack under the engine block in the area shown.
22. Jack up the engine and tilt the engine back until the transfer assembly is lowered approximately 40 mm (1.57 inch).
Note these items when tilting the engine:
-
Check that the wire harnesses, hoses and pipes are not caught by any surrounding parts.
-
Do not tilt the engine more than necessary.
23. Remove the stiffener plate.
NOTE: Some stiffener plate mounting bolts are also used as gearbox mounting bolts. The gearbox will tilt to the side when these bolts are
removed.
