CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
-
Keep grease off the boot installation section and the tapered section of the ball pin.
-
Do not allow dust, dirt, or other foreign materials to enter the heat
4. Install the boot in the groove of the boot installation section securely, then bleed air.
5. Adjust the special tool with the adjusting bolt until the end of the tool aligns with the groove on the boot. Slide the set ring over the tool and into
position.
CAUTION: After installing the boot, check the ball pin tapered section for grease contamination and wipe it if necessary.
Installation
1. Before installing the gearbox, extend the rack all the way to right.
2. Install the mounting cushion on the steering gearbox.
3. Pass the right side of the steering gearbox above and through the right side of the rear beam. Be careful not to bend or damage the two power
steering lines and cylinder lines when installing the gearbox.