CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
9.
Remove the two flange bolts, then remove the valve body unit from the gearbox.
10. Apply vinyl tape to stepped portion of the pinion shaft, and remove the dust cover.
11. Drill a 3 mm (0.12 inch) diameter hole approximately 2.5 - 3.0 mm (0.10 - 0.12 inch) in depth in the staked point on the cylinder. Do not allow
metal shavings to enter the cylinder housing. After removing the cylinder end, remove any burrs at the staked point.
12. Hold the gearbox using using a C-clamp as shown. Loosen and remove the cylinder end.
