CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
13. Assemble a 12 x 1.25 mm flange nut onto a 12 x 175 mm grade 10 flange bolt as shown. Wrap the flange portion of the bolt with vinyl tape to
protect the cylinder.
14. Install the flange bolt into the end of the steering rack until it bottoms in the hole, then back the flange bolt out 1/4 turn. Hold the flange bolt, and
tighten the flange nut against the rack by hand.
15. Install the bearing separator on the gearbox housing as shown.
16. Set the gearbox in a press so the left side points upward, then press the cylinder end seal and steering rack out of the gearbox. Hold the steering
rack to keep it from falling when pressed clear. Be careful not damage to inner surface of the cylinder housing with the flange bolt.
17. Remove the 12 mm bolt and nut from the steering rack.
18. Remove the cylinder end seal from the steering
