CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
53. Set the selected 32 mm shims on the bearing surface of the gearbox housing.
54. Coat the new O-ring with grease, and carefully fit it on the valve housing.
55. Apply grease to the needle bearing in the gearbox housing.
56. Install the valve body unit on the gearbox housing by engaging the gears. Note the valve body unit installation position (direction of line
connection).
57. Tighten the flange bolts to the specified torque.
58. Install the cylinder lines A and B.
Note these items during reassembly:
-
Clean the joints of the cylinder lines A and B thoroughly. The joints must be free of foreign material.
-
Install the cylinder lines A and B by tightening the flare nuts by hand first, then tighten the flare nuts to the specified torque.
59. Grease the sliding surface of the rack guide, and install it onto the gear housing.
