CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
Remove the old sealant from the threads of the rack guide screw, then apply new sealant to the first three threads.
61. Install the spring, rack guide screw, and locknut on the gear housing.
62. Adjust the rack guide screw. After adjusting, check that the rack moves smoothly by sliding the rack right and left.
63. Install the new lockwasher in the groove in the steering rack.
64. Screw the rack ends into the rack.
65. Hold the steering rack with a wrench (left end only), and tighten the rack ends. Be careful not to damage the rack surface with the wrench.
66. After tightening the rack ends, stake the four sections of lock washer with a drift and a mallet.
-
Place the wood block on the press table, then set the lock washer section of the rack end on the wood block securely.
-
Be sure the tool is aligned with the flat sections of the steering rack end before pressing.
-
Stake the lock washer in the center of the flat section of the steering rack end.
67. Apply grease to the circumference of the rack end housing.
