CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
71. Install new boot bands on the boot, and bend both sets of locking tabs.
CAUTION: Stake the band locking tabs firmly.
72. Lightly tap on the doubled-over portions to reduce their height.
73. Slide the rack right and left to be certain that the boots are not deformed or twisted.
74. Connect the air tube between the right and left boot.
75. Install the clips on the cylinder lines, then clamp the air tube with the clips.
76. Apply vinyl tape around the pinion shaft, and coat the surface of the tape with grease.
77. Pack the interior of the dust cover and lip with grease, then install dust cover on the valve body unit.
78. Remove the vinyl tape from the pinion shaft.
