CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
7. Lower the rear suspension, and position the rear damper. The spring stop on the right damper should face rearward, and the spring stop on the left
damper should face forward.
8. Loosely install the two flange nuts.
9. Loosely install the flange bolt.
10. Raise the rear suspension with a floor jack until the vehicle just lifts off the safety stand.
WARNING: The floor jack must be securely positioned or personal injury may result.
11. Tighten the flange bolt.
12. Tighten the two flange nuts on top of the rear damper to the specified torque.
13. Install the damper cap and access panel.
14. Check the rear wheel alignment and adjust if necessary.
