CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
18. Install the backing plate/hub bearing unit on the trailing arm.
19. Install the hub bearing unit in the reverse order of removal, and pay particular attention to the following items:
-
Before installing the spindle nut, apply a small amount of engine oil to the seating surface of the nut. After tightening, use a drift to stake the
spindle nut shoulder against the driveshaft.
-
Avoid twisting the sensor wires when installing the wheel sensor.
-
Fill the brake reservoir, and bleed the brake system.
-
Adjust the parking brake.
-
Check the rear wheel alignment, and adjust it if necessary.
