CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
Shift Interlock Solenoid: Testing and Inspection
Shift Lock Solenoid
SRS components are located in this area. Review the SRS component locations, precautions, and procedures before performing repairs or service.
1. Remove the instrument panel lower cover.
2. Remove the steering column covers.
3. Disconnect the shift lock solenoid 2P connector.
4. Connect the No. 1 terminal of the shift lock solenoid connector to the battery positive terminal, and connect the No. 2 terminal to the battery
negative terminal.
5. Check that the shift lever can be moved from the position. Release the battery terminals from the shift lock solenoid connector. Move the shift
lever back to the P position, and make sure it locks.
NOTE: Do not connect power to the No. 2 (-) terminal (reverse polarity) or you will damage the diode inside the solenoid.
6. Check that the shift lock releases when the release lever is pushed, and check that it locks when the release lever is released.
7. If the solenoid does not work, replace it.
