CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
Clutch Slave Cylinder: Service and Repair
REMOVAL/INSTALLATION
CAUTION:
-
Do not spill brake fluid on the vehicle; it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
-
Plug the end of the clutch line with a shop towel to prevent brake fluid from coming out.
GREASE: Super High Temp Urea Grease (P/N 08798-9002).
GREASE: Brake Assembly Lube or equivalent rubber grease.
1. Disconnect the clutch line from the slave cylinder.
2. Remove the slave cylinder from the clutch housing.
3. Install the slave cylinder in the reverse order of removal.
NOTE: Make sure the boot is installed on the slave cylinder.
