CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
Skill Level:
Repair Technician
Out of warranty:
Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Service Manager or your Zone Office. You
must request consideration, and get a decision, before starting work.
REPAIR PROCEDURE
1.
Drain and refill the rear differential with Dual Pump Fluid.
2.
Check the tires for proper inflation (recommended cold inflation front and rear is 26 psi) and any variation in tire size or type.
3.
est-drive the vehicle in a parking lot. Make tight, low-speed turns.
^
If the noise is eliminated, return the vehicle to the customer.
^
If the noise is still present, go to step 4.
4.
Remove the rear differential assembly (see page 15-16 of the 1997-01 CR-V Service Manual).
5.
Remove the torque control differential case, then remove and discard the 30 mm shim and the clutch assembly (see steps 1 thru 10 on pages 15-20
thru 15-22 of the service manual).
6.
Remove the thrust needle bearing, the oil pump driveshaft, and the oil pump body assembly (see steps 11 and 12 on page 15-22 of the service
manual).
7.
Install the new flow collar over the drive pinion shaft. Make sure the tabs of the flow collar align with the oil pump pin.
