CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
13.
Apply Dual Pump Fluid to the new clutch plates and discs, then assemble the differential clutch. Note these items:
^
Install one metal clutch plate and one fiber clutch disc in the clutch guide, then install the clutch hub with snap ring into the guide.
^
Make sure the splines of the clutch hub and fiber clutch disc are lined up below the snap ring.
^
Install the remaining metal clutch plates and fiber clutch discs alternately until you install a total of 11 plates and 10 discs, then install the
pressure plate.
14.
Align the pressure plate tabs with the oil pump driveshaft notches, then install the new differential clutch assembly onto the pinion shaft.
15.
Remove any dirt and oil from the sealing surfaces of the torque control differential case and the differential housing. Apply Hondabond HT to the
sealing surface of the differential housing. Be sure to seal around all the bolt holes to prevent oil leakage.
