CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
Countershaft: Testing and Inspection
Countershaft Inspection
1. Inspect the gear surface and bearing surface for wear and damage, then measure the countershaft at points A, B. and C.
-
Standard:
A: 36.000 - 36.015 mm (1.4173- 1.4179 inch)
B: 36.984 - 37.000 mm (1.4561 - 1.4567 inch)
C: 24.987 - 25.000 mm (0.9837 - 0.9843 inch)
-
Service Limit:
A: 35.95 mm (1.415 inch)
B: 36.93 mm (1.454 inch)
C: 24.94 mm (0.982 inch)
-
If any part of the countershaft is less than the service limit, replace it with a new one.
2. Inspect for runout.
-
Standard: 0.02 mm (0.0008 inch) max.
-
Service Limit: 0.05 mm (0.002 inch)
NOTE: Support the countershaft at both ends as shown. If the runout exceeds the service limit, replace the countershaft with a new one.
