Del Sol L4-1.5L SOHC (1993)
4.
Remove the door speaker cover. speaker and protective housing. Then reach through the opening. and pull the bottom of the run out of the lower
part of its channel. Pull down on the run until the edges of its weatherstrip are straight.
5.
Press the run back into its channel. Then push the 20 to 40 mm excess length forward under the end of the channel and up past the end of the door
weatherstrip clip, as shown, to keep the run in place.
6.
With the window rolled all the way down, use a soft rubber mallet to carefully narrow the top 100 mm of the run channel. Support the inside of the
run channel with your hand while you work.
7.
After one pass with the mallet, roll the window all the way up. If the glass chatters or binds against the weatherstrip, widen the channel by gently
spreading it with a pair of flat-nose, snap-ring pliers.
8.
Roll the window all the way down, and lightly lube the glass run with Silicone (or Lithium Dielectric) grease.
9.
With the door open, roll the window all the way up, and check that the top of the door glass pushes the end of the glass run up 2 to 3 mm. If more
than 3 mm or less than 2 mm, go to A3, step 3 (Glass Height Adjustment) and adjust the glass height.
10.
Squeeze some Cemedine up under the "eyelid" of the quarter window seal. This will keep water from getting under the top of the quarter window
