honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Body - Water Leak From Roof and Door Window Area|Page 5870 > < Body - Water Leak From Roof and Door Window Area|Page 5868
Page 35
background image

Water can get around the front edge of the door glass through gaps in the weatherstrip. The gaps may be caused by the glass run riding up in its channel
(the edges of the weatherstrip look wavy), or by the channel being too wide (the weatherstrip edges are straight but don't touch the glass).

1.

With the window up, inspect the top end of the glass run.

^

If the corner is torn, cracked, or split, go to B2, and replace the run.

^

If the corner is OK, go to step 2.

2.

Roll the window down, loosen the screw in the top of the quarter window, and pull the top of the quarter window seal up and toward the rear of the
car.

3.

Pull the glass run out of its channel (to break the surface adhesion), and then push it back in, and roll the window up.

4.

Remove the door speaker cover. speaker and protective housing. Then reach through the opening. and pull the bottom of the run out of the lower
part of its channel. Pull down on the run until the edges of its weatherstrip are straight.

Body - Water Leak From Roof and Door Window Area|Page 5870 > < Body - Water Leak From Roof and Door Window Area|Page 5868