Del Sol L4-1.5L SOHC (1993)
10.
Cut a piece of EPT Sealer 3T to an approximate length of 6 x 400 mm. Apply the EPT to the outside edge of the glass run channel as shown; then
reinstall the run channel into the front glass guide.
NOTE:
Make sure that the EPT is not sticking out of the front glass guide after installing the glass run channel.
11.
Roll up the window, and check that the top of the door glass pushes up on the run channel rubber approximately 1 - 2 mm when the window stops.
12.
If necessary, adjust the window glass height. Roll the window down completely, then unlock the front and rear stopper plates. Turn both of the
stopper plate adjustments equally, one full turn counterclockwise, to move the window up 1-2 mm.
