Del Sol L4-1.5L SOHC (1993)
13.
For del Sol S models below VIN 003394 and del Sol Si models below VIN 004060, inspect the A pillar weatherstrip for a drain hole in the drip
rail area.
14.
If there is no drain hole, drill a hole using a modified feed pipe (P/N 22722-PF4-000). Modify the feed pipe by using a medium grit grinding wheel
to grind the tip to a 60-degree angle.
15.
Place the modified feed pipe in the drip rail channel approximately 1 mm behind the molded bump. Using light pressure, spin the feed pipe
back-and-forth between your hands until a hole is made through the outside portion of the A pillar weatherstrip.
16.
Check that the roof side seal and A pillar weatherstrip are flush at their mating surfaces. If the roof side seal is not flush with the A pillar
weatherstrip, adjust the roof side seal.
17.
Unlock the roof, and lift up the front edge of the roof. Place a shop towel between the roof and A pillar weatherstrip to support the roof.
