Del Sol L4-1.5L SOHC (1993)
10.
Check that the rotor is still pointing toward the No. 1 cylinder, then align the index mark on the housing with the index mark on the coupling.
11.
Drive in the pin and secure it with the pin retainer.
INSTALLATION
12.
Coat a new 0-ring with engine oil then install it.
13.
Slip the distributor into position.
NOTE: The lugs on the end of the distributor and its mating grooves in the camshaft end are both offset to eliminate the possibility of installing
the distributor 180~ out of time.
Distributor Installation
14.
Install the hold-down bolts and tighten temporarily.
15.
Connect the 2-P and 8-P connectors to the distributor.
Spark Plug Wire Cap Location
16.
Connect the spark plug wires as shown.
17.
Set the timing with a timing light.
18.
After adjusting, tighten the hold-down bolts, then install the cap on the bolt.
Torque: 22 Nm (16 ft-lbs)
