Del Sol Si VTEC L4-1590cc 1.6L DOHC (VTEC) MFI (1997)
_mfi/Page-1303010.png)
Installing Brake Spring Compressor On Spring Cover
10. Install the special tool on the spring cover, and turn the shaft until the locknut contacts the plate.
11. Check that the flared end of the spring cover is below the circlip groove.
Installing Circlip In Groove
12. Install the circlip in the groove, then remove the special tool.
NOTE: Check that the circlip is seated in the groove properly.
13. Coat a new piston seal with recommended silicone grease in the caliper seal set, and install it in the caliper.
