Del Sol Si VTEC L4-1590cc 1.6L DOHC (VTEC) MFI (1997)
Ignition Cable: Testing and Inspection
CAUTION: Carefully remove the ignition wires by pulling on the rubber boots. Do not bend the wires; you might break them inside.
Ignition Wire Inspection And Test
1. Check the condition of the wire terminals. If any terminal is corroded, clean it, and if it is broken or distorted, replace the wire.
Ignition Wire Inspection And Test
2. Connect ohmmeter probes and measure resistance.
Ignition Wire Resistance: 25 k ohms max. at 68°F (20°C)
3. If resistance exceeds 25 k ohms, replace the ignition wire.