Del Sol Si VTEC L4-1590cc 1.6L DOHC (VTEC) MFI (1997)
_mfi/Page-1603002.png)
Driver's Side Airbag Access Panel
3. Remove the access panel, then disconnect the 2P connector between the driver's airbag and the cable reel.
Driver's Side & Front Passenger's Airbag
4. Cut off the airbag connector, strip the ends of the airbag wires, and connect the special tool alligator clips to the airbag. Place the special tool
approximately thirty feet (10 meters) away from the airbag.
5. Connect a 12 volt battery to the tool.
-
If the green light on the tool comes on, the airbag igniter circuit is defective and cannot deploy the airbag. Refer to Damaged Airbag Special
Procedure .
-
If the red light on the tool comes on, the airbag is ready to be deployed.
6. Push the tool's deployment switch. The airbag should deploy deployment is both highly audible and visible; a loud noise and rapid inflation of the
bag, followed by slow deflation).
-
If the airbags deploy and the green light on the tool comes on, continue with this procedure.
-
If an airbag doesn't deploy, yet the green light comes ON, its igniter is defective. Refer to Damaged Airbag Special Procedure .
WARNING: During deployment, the airbag assembly can become hot enough to burn you. Wait thirty minutes after deployment before
touching the assembly.
Airbag Assembly / Proper Disposal
7. Dispose of the complete airbag assembly. No part of it can be reused. Place it in a sturdy plastic bag, and seal it securely.
