Element 2WD L4-2.4L (2003)
2.
Slightly loosen the striker bolts, and adjust the striker in or out to get the proper measurement. Torque the striker bolts to 22 N.m (16 lb-ft).
3.
Check the tailgate for drag by holding in the release lever and opening and closing the tailgate.
^
If the tailgate does not drag, go to step 5.
^
If the tailgate drags, go to step 4.
4.
The tailgate strikers will drop when loosened. Mark the original position before loosening the striker bolts. Slightly loosen the striker bolts, and
adjust the strikers up and down to eliminate any drag. Torque the striker bolts to 22 N.m (16 lb-ft).
5.
Check the adjustment of the hatch. The hatch edge should be even with or 1 mm below the fender.
^
If the adjustment is correct, go to step 7.
^
If the adjustment is not correct, go to step 6.
6.
If the hatch sits out too far, screw the hatch edge cushions in two full turns. If it sits in too far, screw the hatch edge cushions out two full turns.
7.
Check the hatch for latch drag by holding in the release lever and opening and closing the hatch door.
^
If the latch does not drag, the repair is complete.
^
If the latch drags, go to step 8.
8.
Slightly loosen the center striker bolts. While holding in the release lever, open and close the hatch to align the striker. Adjust the striker as needed
to eliminate any drag. Torque the striker bolts to 22 N.m (16 lb-ft).
Disclaimer
