Element 2WD L4-2.4L (2003)
Variable Valve Timing Actuator: Service and Repair
VTC Oil Control Solenoid Valve Removal/Test/Installation
1. Disconnect the VTC oil control solenoid valve connector (A).
2. Remove the bolt (B) and the VTC oil control solenoid valve (C).
3. Check the VTC oil control solenoid valve for sticking or clogging. If the valve is stuck or clogged, replace it, then go to step 7.
4. Check the clearance between the port (advance side) and the valve. Make sure the valve (A) closes fully.
5. Connect the battery positive terminal to VTC oil control solenoid valve 2P connector terminal No.2.
6. Connect the battery negative terminal to VTC oil control solenoid valve 2P connector terminal No.1 Clearance (A) should be at least 2.3 mm
(1/16 in.) If the valve does not open, replace it; then go to step?.
