Element 2WD L4-2.4L (2003)
10.
Install the new ELD and bus bar.
11.
Reinstall the two fuses.
12.
Reconnect the 3P ELD connector, and reinstall the lower cover onto the fuse/relay box.
13.
Reinstall the fuse/relay box and the wire harness clip onto the holder.
14.
Reinstall the fuse/relay box cover.
15.
Reconnect the negative battery cable.
16.
Clear the DTC.
17.
*Reset the power window control unit:
^
Turn the ignition switch to ON (II), and make sure the driver's window AUTO function does not work.
^
Start the engine.
^
Push down the driver's power window switch to the second detent (AUTO down) to lower the driver's window all the way down. When the
window reaches the bottom, hold the switch in the AUTO down position for 2 more seconds.
^
Pull up the driver's power window switch to raise the driver's window all the way up without stopping. When the window reaches the top, hold
the switch in the up position for 2 more seconds.
^
If the driver's window AUTO function does not work, repeat this power window control unit reset procedure.
18.
Do the idle learn procedure:
^
Make sure all electrical items (A/C, audio unit, defogger, lights, etc.) are off.
^
Start the engine, and let it warm up to its normal operating temperature (the cooling fans cycle twice).
^
Let the engine idle (throttle closed and all electrical items off) for 10 minutes.*
19.
Enter the audio system anti-theft code, and set the clock. Enter the audio unit presets.
Disclaimer
