Element 2WD L4-2.4L (2003)
2.
Clear the SRS DTC memory.
3.
Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.
^
If the SRS indicator goes off and the DTC does not return, go to REPAIR PROCEDURE and replace the appropriate rear door harness.
^
If the SRS indicator stays on and the DTC returns, this bulletin may not apply. Follow the service manual procedure to troubleshoot the DTC.
Refer to page 23-46 for SRS DTC 3-1, or page 23-60 for SRS DTC 4-1 in the 2003-2006 Element Service Manual.
NOTE:
The conditions that cause the resistance in C771 or C761 to trigger DTC 3-1 or DTC 4-1 are intermittent and difficult to repeat. If the code
returns after it is cleared, it is likely that there is another problem in the system.
REPAIR PROCEDURE
1.
Remove the rear side area trim panel:
^
Refer to page 20-60 of the 2003-2006 Element Service Manual, or
^
Online, enter keywords REAR TRIM, then select Interior Trim Removal/Installation - Rear Side Area from the list.
2.
Remove the rear door panel:
^
Refer to page 20-19 of the service manual, or
^
Online, enter keywords REAR PANEL, then select Rear Door Panel Removal/Installation from the list.
3.
Disconnect the rear door subharness from the floor wire harness.
NOTE:
The left rear door harness is shown; the right rear door harness is similar.
4.
Remove the rear door hinge lower cover.
