Element 2WD L4-2.4L (2003)
66. Coat the inside and outside surfaces of the new cylinder end seal (A) with power steering fluid.
67. Install the cylinder end seal onto the steering rack (B) with its grooved side (C) toward the piston. Push in the cylinder end seal with your finger.
68. Place the backup ring (D) on the cylinder end seal with its flat side facing upward. Then drive the backup ring in with the appropriate size socket
wrench until the its surface is below the internal snap ring groove (E). Install the snap ring (F) in the groove.
69. Install the new lock screw (A) on the cylinder.
70. Install the new stop ring (B) in the groove (C) on the cylinder by expanding it with snap ring pliers. Be careful not to scratch or damage on the
cylinder surface with the stop ring edges.
71. Coat the housing surface with multipurpose grease as shown.
