Element 2WD L4-2.4L (2003)
5. Pry the lock tabs on the back of the O/D switch/shift lock solenoid connector (A), and remove the back cover (B).
6. Remove the terminal (C) from the connector by pushing the lock tab (D) up in the connector using a thin blade screwdriver (E). Remove all four
terminals.
7. Remove the O/D switch harness clamp from the shift lever bracket and from the harness, and pull the O/D switch harness out to remove the shift
lever assembly.
8. Remove the shift lock solenoid harness clamp from the shift lever bracket, and remove the shift lock solenoid.
9. Remove the park pin switch from the shift lever bracket.
10. Replace the shift lever/bracket assembly.
11. Install the shift lock solenoid (A) on the shift lever/ bracket assembly (B) with aligning the shift lock solenoid plunger (C) with the tip of the shift
lock stop (D).
12. Install the harness clamp (E) on the shift lock solenoid harness (F) at 128 - 138 mm (5.0 - 5.4 inch) (G) from the harness terminal end.
13. Install the clamp in the hole (H) of the shift lever bracket.
14. Install the shift lever ring (A) to the shift lever (B).
15. Insert the O/D switch harness (C) into the shift lever ring, and route the harness through the groove (D) of the shift lever into the hole (E). Do not
pinch the harness.
