Element 2WD L4-2.4L (2003)
^
The left end goes behind the notch on the interlock lever.
^
Once the spring is correctly installed, make sure the lever moves freely and returns properly.
10. Insert the plunger into the interlock solenoid, then install the solenoid using a new screw. Make sure the groove of the solenoid plunger is in the fork
on the lever.
11. Install a new plastic cover on the interlock solenoid.
12. Check the operation of the ignition switch key interlock:
^
Set the parking brake, and turn the ignition switch to ON (I I).
^
While pressing the brake pedal, shift the transmission to Neutral.
^
Try turning the ignition switch to LOCK (0)
-
If you cannot turn the switch to LOCK (0), your repair was successful; go to step 15.
-
If you can turn the switch to LOCK (0), the interlock is not working; go to step 13.
