Element 2WD L4-2.4L (2003)
7. Apply a small amount of Permalube grease to the base of the new lever. Then attach the slide hammer to the new lever pin, insert the lever into the
ignition switch, and seat the pin with the slide hammer.
8. Check the installed height of the pin with vernier calipers. If the height is more than 5.0 mm, the pin is not seated. If needed, reattach the slide
hammer, and seat the pin.
NOTE:
It's normal for the interlock lever to be loose, even when the pin is fully seated.
9. Install a new spring on the lever. Make sure you attach the ends of the spring correctly:
^
The right end goes into the slot on the ignition switch.
