Element 2WD L4-2.4L (2003)
1. Remove and discard the plastic cover from the ignition switch key interlock solenoid.
2. Note the position of the interlock solenoid plunger; you'll need to install it the same way.
3. Remove the screw from the solenoid, but keep the solenoid attached to its electrical connector. Discard the screw.
NOTE:
^
Be careful not to lose the solenoid plunger; it slides out easily.
^
Keep the plunger free of dirt and grease while it's removed from the solenoid.
4. Note the position of the interlock lever spring; you'll need to install the new spring the same way.
