Element 2WD L4-2.4L (2003)
12. With a sponge, apply a light coat of glass primer to the edge of the glass (A) add along the rubber dam (B) as shown, then tightly wipe it off with
gauze or cheesecloth:
-
Do not apply body primer to the quarter glass, and do not get body and glass primer sponges mixed up.
-
Never touch the primed surfaces with your hands. If you do, the adhesive may not bond to the quarter glass properly, causing a leak after the
quarter glass is installed.
-
Keep water, dust, and abrasive materials away from the primed surface.
13. With a sponge, carefully apply a light coat of body primer to any exposed paint around the flange where new adhesive will be applied. Let the
primer dry for at least 10 minutes:
-
Do NOT apply body primer to any remaining original adhesive on the flange.
-
Be careful not to mix up the body and glass primer sponges.
-
Never touch the primed surfaces with your hands.
