Element 4WD L4-2.4L (2004)
Air Door Actuator / Motor: Testing and Inspection
Recirculation Control Motor Circuit Troubleshooting
Recirculation Control Motor Circuit Troubleshooting
1. Check the No. 14 (10 A) fuse in the under-dash fuse/relay box.
Is the fuse OK?
YES - Go to step 2.
NO - Replace the fuse, and recheck.
2. Disconnect the recirculation control motor 7P connector.
3. Turn the ignition switch ON (II).
4. Measure the voltage between the No. 1 terminal of the recirculation control motor 7P connector and body ground.
Is there battery voltage?
YES - Go to step 5.
NO - Repair open in the wire between the No. 14 fuse in the under-dash fuse/relay box and the recirculation control motor.
5. Turn the ignition switch OFF.
6. Test the recirculation control motor.
Is the recirculation control motor OK?
YES - Go to step 7.
NO - Go to step 13.
7. Disconnect the heater control panel 30P connector.
8. Check for continuity between the No. 5 and No. 6 terminals of the heater control panel 30P connector and body ground individually.
Is there continuity?
YES - Repair any short to body ground in the wire(s) between the heater control panel and the recirculation control motor.
NO - Go to step 9.
