Element 4WD L4-2.4L (2004)
10. Check for continuity between DLC terminal No.7 and ECM/PCM terminal E23.
Is there continuity?
YES - Update the ECM/PCM if it does not have the latest software, or substitute a known-good ECM/PCM, then recheck. If the
symptom/indication goes away with a known-good ECM/PCM, replace the original ECM/PCM.
NO - Repair open in the wire between DLC terminal No.7 and the ECM/PCM (E23). After repairing the wire, check for a DTC with the Honda
PGM Tester or the HDS, then go to the DTC Troubleshooting index. See: Testing and Inspection/Diagnostic Trouble Code Descriptions
11. Turn the ignition switch OFF.
12. Jump the SCS line with the Honda PGM Tester or the HDS.
13. Disconnect ECM/PCM connector E (31P).
14. Turn the ignition switch ON (II).
15. Measure voltage between DLC terminals No.5 and No.7.
Is there 0 V?
YES - Update the ECM/PCM if it does not have the latest software, or substitute a known-good ECM/PCM, then recheck. If the
symptom/indication goes away with a known-good ECM/PCM, replace the original ECM/PCM.
NO - Repair short to power in the wire between DLC terminal No.7 and the ECM/PCM (E23). After repairing the wire, check for a DTC with the
Honda PGM Tester or the HDS, then go to the DTC Troubleshooting index. See: Testing and Inspection/Diagnostic Trouble Code Descriptions
