Element 4WD L4-2.4L (2004)
Power Door Lock Control Module: Testing and Inspection
Control Unit Input Test
NOTE: Before testing, troubleshoot the multiplex control system .
1. Remove the driver's dashboard lower cover.
2. Disconnect the under-dash fuse/relay box connectors J, M, P, Q, X and Y.
NOTE: All connectors are wire side of female terminals.
3. Inspect the connector and socket terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK, go to step 4.