Element 4WD L4-2.4L (2004)
Power Window Control Module: Programming and Relearning
Power Window Control Unit Reset
Resetting the power window control unit is required after performing the following procedures:
-
Loss of battery power
-
Loss of power from the No. 23 (20A) fuse in the under-dash fuse/relay box
-
Open circuit caused by disconnecting the 14P connector from the power window master switch.
1. Make sure the driver's window does not work in AUTO with the ignition switch ON (II).
2. Start the engine.
3. Lower the driver's window all the way down by pushing the driver's power window switch to the second detent (AUTO DOWN); when the window
reaches the bottom, hold the switch in the AUTO DOWN position for 2 seconds.
4. Raise the driver's window all the way up without stopping by pulling the driver's power window switch to the UP position; when the window reaches
the top, hold the switch in the UP position 2 seconds.
5. If the window does not work in AUTO, repeat Step 2 through 5.
