Element 4WD L4-2.4L (2004)
Standard: 50 Ohms - 25 k Ohms
9. If the resistance is out of standard, replace the shift solenoid harness. The ATF temperature sensor is not available separately from the shift
solenoid harness.
10. Disconnect the connectors from the shift solenoid valves.
11. Connect the shift solenoid valve A connector (BLU wire) with the ATF temperature sensor (F) on the new solenoid harness.
12. Connect the solenoid valve B connector (ORN wire), solenoid valve C connector (GRN wire), and solenoid valve E connector (RED wire).
13. Install the new O-ring (G) on the shift solenoid harness connector (H), and install the connector in the transmission housing.
14. Install the shift solenoid valve cover with the new gasket and dowel pins.
15. Install the ATF cooler inlet line with the line bolt and the new sealing washers. Create clearance with the jack between the transmission and the
front subframe to tighten the line bolt with the torque wrench.
16. Install the bracket of the ATF cooler inlet line on the shift solenoid valve cover with the bolt.
17. Check the connector for rust, dirt, or oil, clean if needed, then connect the connector securely.
18. Remove the transmission jack.
19. Refill the transmission with the recommended fluid.
