Element 4WD L4-2.4L (2004)
62. Install the new backup ring (A) on the steering rack, then place the backup ring and cylinder end seal (B) against the piston (C).
63. Mark (A) a position on the steering rack surface with a felt-tip marker, 7.7 mm (0.3 inch) from the rack end.
64. Apply power steering grease to the steering rack teeth, then insert the steering rack (A) into the cylinder (B). Be careful not to damage the inner
surface of the cylinder wall and bushing with the rack edges.
65. Set the cylinder (A) in a press, then press the cylinder end seal (B) into the bottom of the cylinder until the mark (C) on the rack meets the edges
(D) of the cylinder.
