Element 4WD L4-2.4L (2004)
14. Lift up the boot band tool to bend the free end of the band 90 degrees to the clip. Center-punch the clip, then fold over the remaining tail onto the
clip.
15. Unwind the boot band tool, and cut off the excess free end of the band to leave 5 - 10 mm (0.2 - 0.4 inch) tail protruding from the clip.
16. Bend the band end (A) by tapping it down with a hammer.
NOTE:
^
Make sure the band and clip do not interfere with anything, and the band does not move.
^
Remove any grease remaining on the surrounding surfaces.
17. Install the boot band on the other end of the boot, and repeat steps 9 through 16.
18. Install the new set ring.
Rear Driveshaft Installation
Rear Driveshaft Installation
NOTE: Before starting installation, make sure the mating surfaces of the joint and the splined section are free from dirt or dust.
