Fit L4-1.5L (2008)
-
When removing or installing the side curtain airbag inflator assembly, never handle the flexible bag (B).
SRS Unit, Impact Sensors, Driver's Seat Position Sensor, and Front Passenger's Weight Sensors
-
Be careful not to bump or impact the SRS unit, front impact sensors, or side impact sensors whenever the ignition switch is ON (II), or for at least
3 minutes after the ignition switch is turned OFF.
-
During installation or replacement, be careful not to bump (by impact wrench, hammer, etc.) the area around the SRS unit, front impact sensors, or
the side impact sensors. The airbags could accidentally deploy and cause damage or injury.
-
After a collision where the airbags the side airbags, the side curtain airbags, or seat belt tensioners were deployed, many components must be
inspected. After a collision where the airbags, the side airbags, or the side curtain airbags did not deploy, inspect for any damage or any
deformation on the SRS unit, front impact sensors, and the side impact sensors. If there is any damage, replace the SRS unit and/or the sensors.
-
Do not disassemble the SRS unit, front impact sensors, side impact sensors, driver's seat position sensor, or front passenger's weight sensors.
-
Turn the ignition switch OFF, disconnect the negative cable from the battery, then wait for 3 minutes before starting installation or replacement of
the SRS unit, or disconnecting the connectors from the SRS unit.
-
Be sure the SRS unit, front impact sensors, and side impact sensors are installed securely with the mounting bolts torqued to 9.8 Nm (1.0 kgf.m,
7.2 lbf.ft)
-
Do not spill water or oil on the SRS unit or the side impact sensors, and keep them away from dust.
-
Store the SRS unit, front impact sensors, and side impact sensors in a cool (less than 104 °F/40 °C) and dry (less than 80 % relative humidity, no
moisture) area.
Wiring Precautions
Some of the SRS wiring can be identified by special yellow outer covering, and the SRS connectors can be identified by their yellow color. Observe the
instructions.
-
Never attempt to modify, splice, or repair SRS wiring. If there is an open or damage in SRS wiring, replace the harness.
