Fit L4-1.5L (2008)
-
Be sure to install the harness wires so they do not get pinched or interfere with other parts.
-
Make sure all SRS ground locations are clean, and grounds are securely fastened for optimum metal-to-metal contact. Poor grounds can cause
intermittent problems that are difficult to diagnose.
Precautions for Electrical Inspections
-
When using electrical test equipment, insert the probe of the tester into the wire side of the connector. Do not insert the probe of the tester into the
terminal side of the connector, and do not tamper with the connector.
-
Use a U-shaped probe. Do not insert the probe forcibly.
-
Use specified service connectors in troubleshooting. Using improper tools could cause an error in inspection due to poor metal-to-metal contact.
