Fit L4-1.5L (2008)
Cruise Control Switch: Testing and Inspection
Cruise Control Combination Switch Test/Replacement
SRS components are located in this area. Review the SRS component locations and precautions and procedures before performing repairs or service.
1. Remove the driver's airbag.
2. Remove the three screws, then disconnect the connector (A), and remove the cruise control combination switch (B).
3. Check for continuity between the terminals in each switch position according to the table.
-
If there is continuity, and it matches the table, but switch failure occurred on the cruise control input test, check and repair the wire harness on
the switch circuit.
-
If there is no continuity in one or both positions, replace the switch.
4. Check for continuity between the terminals in according to the table.
-
If there is continuity, and it matches the table, check and repair the wire harness on the switch circuit.
-
If there is no continuity in one or more positions, replace the switch.