Fit L4-1.5L (2008)
10. Clean the camshaft bearing surfaces in the cylinder head. Measure the inside diameter of each camshaft bearing surface, and check for an out-of
round condition.
^
If the camshaft-to-holder clearance is within limits, go to step 12.
^
If the camshaft-to-holder clearance is beyond the service limit and the camshaft has been replaced, replace the cylinder head.
^
If the camshaft-to-holder clearance is beyond the service limit and the camshaft has not been replaced, go to step 11.
11. Check the total runout with the camshaft supported on V-blocks.
^
If the total runout of the camshaft is within the service limit, replace the cylinder head.
^
If the total runout is beyond the service limit, replace the camshaft and recheck the camshaft-to-holder oil clearance. If the oil clearance is still
beyond the service limit, replace the cylinder head.