Fit L4-1.5L (2008)
Rocker Arm Assembly: Testing and Inspection
Rocker Arm and Shaft Inspection
Rocker Arm and Shaft Inspection
1. Remove the rocker arm assembly.
2. Measure the diameter of the shaft at the first rocker location.
3. Zero the gauge (A) to the shaft diameter.
4. Measure the inside diameter of the rocker arm, and check it for an out-of-round condition.
5. Repeat for all rocker arms and shaft. If the clearance is over the limit, replace the rocker shaft and all overtolerance rocker arms. If any VTEC
rocker arm needs replacement, replace the rocker arms (primary and secondary) as a set.
6. Inspect the rocker arm pistons (A). Push each piston manually.
